1986-1993 Mustang MegaSquirt Gen2 Plug and Play ECU EEC4A8

1986-1993 Ford Mustang 5.0 & 1986-1988 Ford Thunderbird 5.0 with manual or factory automatic transmisssions! Easy to Use and Install! (Can be reconfigured for some other EEC-IV equipped cars with internal jumper changes by special order – contact us for details)

MegaSquirtPNP Model #EEC4A8 Features:

• Fully Plug and Play Installation – No wiring required for basic functionality. Average install time is under 1 hour!
• 5.0 HO base maps is pre-loaded to help your engine start on the first turn of the key
• Real time tuning and data logging with a laptop connection
• Supports most aftermarket wideband sensors
• Uses internal MAP sensor – can be used on both cars with factory MAF or speed density
• Mounts in the stock location – case is specifically designed to use factory mounting points

Fully Tunable Engine Control!

• 16×16 Fuel Tables allow high resolution tuning
• Bank to bank fuel control
• 12×12 Ignition Tables
• Multiple Acceleration enrichment strategies
• Closed Loop Idle Speed Control
• Retains air conditioner function
• Onboard peak and hold drivers support both high or low impedance injectors – No external ballast resistor is needed!
• Allows removal of stock MAF sensor, if so equipped

Advanced Feature Set (Included!)

• 12×12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
• Built-in 2-step rev limiter / launch control with flat shift
• Real time barometric correction
• Internal 4-bar MAP sensor reads up to 44PSI of boost
• Overboost protection
• Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
• Knock sensor input with adjustable sensitivity
• Headphone output for knock sensor – listen for knock while you tune!
• Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
• Input for flex fuel sensor – switch between E85 and gasoline on the fly!
• CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors)…..the possibilities are limitless!

What you get in the box:

• MegaSquirtPNP EEC4A8 ECU
• MSPNP RS232 serial tuning cable, 6′ (USB adapter sold separately, if needed)
• Tuning Software and Documentation USB Stick with TunerStudio Lite
• 6′ Vacuum Hose for MAP Signal and ‘T’ fitting