1979-1993 Mustang Maximum Motorsports 5/8 Bolt Through Bumpsteer Kit
1979 to 1993 Mustang
- Gift Ideas & Accessories
- Accessories and Accents
- Body Parts and Sheet Metal
- Books and Manuals
- Brakes
- Convertible
- Cooling System
- Custom Tuning and Calibration
- Decals
- Electrical
- Emblems
- Engine 5.0L/5.8L
- Exhaust
- Fire Suppression System
- Fuel System
- Heat and Air Conditioning
- Ignition
- Interior
- Lighting
- Locks and Lock Sets
- Lubricants
- Paint and Restoration Supplies
- Sound and Heat Insulation
- Stripe Kits and Decals
- Superchargers
- Suspension and Steering
- Transmission And Differential
- Trunk Area Parts
- Turbochargers
- Weatherstripping and Rubber Parts
- Wheel and Tire
- Windshield Wiper and Washer Parts
Click Any Photo to Enlarge
Bumpsteer is a term for the situation where the front toe changes as the suspension moves up and down. If the toe changes more than a very small amount it will cause the car to change direction, making the car unstable and unpredictable. MM offers two types of Adjustable Tie-Rod Ends. The tapered stud type can be used to make moderate changes to the geometry. It is best suited for use with a stock K-member, and does not require any modification to the spindle. The bolt-through spindle type has a much wider range of adjustment. It is required for most situations when installing a MM K-Member and requires drilling out the tapered hole in the spindle to accept a 5/8" bolt.
The installation of any adjustable tie-rod end requires that your car be measured for bumpsteer. This can be done by following our copyrighted step-by-step instructions.
Manufactured / Distributed By:
