MSD Distributorless Ignition Tachometer Adapter
1994 to 2004 Mustang
- Gift Ideas & Accessories
- Books and Manuals
- Brakes
- Convertible
- Cooling System
- Custom Tuning and Calibration
- Decals
- Differential
- Electrical
- Engine
- Exhaust
- Exterior
- Fuel System
- Heat and Air Conditioning
- Ignition
- Interior
- Lubricants
- Stripes and Decals
- Suspension and Steering
- Transmission
- Trunk Area Parts
- Turbochargers
- Weatherstripping and Rubber Parts
- Wheel and Tire
- Windshield Wiper and Washer Parts
Click Any Photo to Enlarge
The MSD distributorless ignition tachometer adapter allows you to install an aftermarket tachometer on vehicles with no distributor and multiple coil packs. The compact tach driver measures only 1.5"x 3.5"x 2" and is potted with a polyurethane compound for vibration and water protection so it can easily be mounted under the hood. It wires inline on the coils' 12 volt supply wire where it senses the current going through this wire and converts this information into a 12 volt output signal that most aftermarket tachometers use as a trigger signal. It can be used on 4, 6 or 8-cylinder engines. Tach adapter can not be used with Capacitive Discharge Ignition. (Such as MSD Ignition control) Voltage on positive side of coil must be below 18 volts. Sold individually
Manufactured / Distributed By:
Also Found in:
