1986 to 2004 Mustang Billet Aluminum Driveshaft Spacer
1994 to 2004 Mustang
- Gift Ideas & Accessories
- Books and Manuals
- Brakes
- Convertible
- Cooling System
- Custom Tuning and Calibration
- Decals
- Differential
- Electrical
- Engine
- Exhaust
- Exterior
- Fuel System
- Heat and Air Conditioning
- Ignition
- Interior
- Lubricants
- Stripes and Decals
- Suspension and Steering
- Transmission
- Trunk Area Parts
- Turbochargers
- Weatherstripping and Rubber Parts
- Wheel and Tire
- Windshield Wiper and Washer Parts
Click Any Photo to Enlarge
- 8.8" Rear End 5/8" Billet Driveshaft Spacer
- Billet Aluminum
- 15 Minute Install
- Required when installing Tremec Transmission
- Direct Bolt In
Installing a Tremec Transmission in your Mustang? Then you will need a driveshaft spacer to make up for the difference in length or get a custom made driveshaft to make up the 3/8-5/8". Our 5/8" Billet Aluminum driveshaft spacer makes up that difference and includes longer hardware for a seemless installation. Being made from Billet Aluminum means less rotational mass and will keep your drivesaft at the proper length to prevent yoke failure.
For 1994 - 1995 Transmission Swaps.
Manufactured / Distributed By:
Also Found in:
